Translations:Betriebsregeltypen/6/en - Versionsgeschichte

T.Schnellbach am 31. März 2021 um 06:09 Uhr

2021-03-31T06:09:46Z

← Nächstältere Version		Version vom 31. März 2021, 08:09 Uhr
Zeile 1:		Zeile 1:
	When specifying discharges according to an operating rule, it is assumed that the outlet capacity is sufficient to meet these discharges. Thus, dimensioning the outlet element must consider the operating requirements. In principle, the physically possible discharge, given by the characteristic curve ~~of the outlets~~ at full opening, ~~is fixed as~~ the upper limit value.		When specifying discharges according to an operating rule, it is assumed that the outlet capacity is sufficient to meet these discharges. Thus, dimensioning the outlet element must consider the operating requirements. In principle, the physically possible discharge, given by the outlet's characteristic curve at full opening, sets the upper limit value.

T.Schnellbach am 24. März 2021 um 10:17 Uhr

2021-03-24T10:17:13Z

← Nächstältere Version		Version vom 24. März 2021, 12:17 Uhr
Zeile 1:		Zeile 1:
	When specifying discharges according to an operating rule, it is assumed that the capacity ~~of the outlets~~ is sufficient to meet these discharges. Thus, dimensioning the outlet element must consider the operating requirements. In principle, the physically possible discharge, given by the characteristic curve of the outlets at full opening, is fixed as the upper limit value.		When specifying discharges according to an operating rule, it is assumed that the outlet capacity is sufficient to meet these discharges. Thus, dimensioning the outlet element must consider the operating requirements. In principle, the physically possible discharge, given by the characteristic curve of the outlets at full opening, is fixed as the upper limit value.

T.Schnellbach am 24. März 2021 um 10:12 Uhr

2021-03-24T10:12:09Z

← Nächstältere Version		Version vom 24. März 2021, 12:12 Uhr
Zeile 1:		Zeile 1:
	When specifying ~~releases~~ according to an operating rule, it is assumed that the capacity of the outlets is ~~sufficiently large~~ to meet these ~~releases~~. Thus, ~~the~~ dimensioning of the outlet element must ~~take into account~~ the requirements ~~of the water management operation. Usually there will be no problems in this respect~~. In principle~~, however~~, the physically ~~feasible~~ discharge, given by the characteristic curve of the outlets at full opening, is fixed as the upper limit value.		When specifying discharges according to an operating rule, it is assumed that the capacity of the outlets is sufficient to meet these discharges. Thus, dimensioning the outlet element must consider the operating requirements. In principle, the physically possible discharge, given by the characteristic curve of the outlets at full opening, is fixed as the upper limit value.

Ferrao: Die Seite wurde neu angelegt: „When specifying releases according to an operating rule, it is assumed that the capacity of the outlets is sufficiently large to meet these releases. Thus, the…“

2020-11-25T10:32:53Z

Die Seite wurde neu angelegt: „When specifying releases according to an operating rule, it is assumed that the capacity of the outlets is sufficiently large to meet these releases. Thus, the…“

Neue Seite

When specifying releases according to an operating rule, it is assumed that the capacity of the outlets is sufficiently large to meet these releases. Thus, the dimensioning of the outlet element must take into account the requirements of the water management operation. Usually there will be no problems in this respect. In principle, however, the physically feasible discharge, given by the characteristic curve of the outlets at full opening, is fixed as the upper limit value.