Fehlermeldungen/en: Unterschied zwischen den Versionen

Aus TALSIM Docs
(Die Seite wurde neu angelegt: „*In the system administration the decimal separator is not set to dot. : Special:MyLanguage/Fil…“)
(Die Seite wurde neu angelegt: „*Simulation period is outside the date of the time series *In the state groups the calculation order was not updated when inserting new control groups *Overflo…“)
Zeile 13: Zeile 13:
: [[Special:MyLanguage/File:Error message001.png|400px]]
: [[Special:MyLanguage/File:Error message001.png|400px]]


*Simulationszeitraum liegt außerhalb des Datums der Zeitreihen
*Simulation period is outside the date of the time series
*In den Zustandsgruppen wurde die Berechnungsreihenfolge beim Einfügen neuer Kontrollgruppen nicht aktualisiert
*In the state groups the calculation order was not updated when inserting new control groups
*Überlaufen von Speicherelementen, aufgrund eines zu großen Zuflusses bzw. zu kleinen Abflusses. Einfügen eines Notüberlaufs ist notwendig.  
*Overflow of storage elements, due to too large inflow or too small outflow. Inserting an emergency overflow is necessary.  
*Fehler in den Regeln und Steuerungen
*Error in the rules and controls





Version vom 13. November 2020, 15:37 Uhr

Sprachen:

ERROR-File

During each simulation the data set is temporarily stored under D:\Talsim-NG\Client\TalsimNG\Simulation. They are deleted again after closing TALSIM NG. If the simulation is aborted, an ASCII file *.ERR is created which contains a short description of the cause of the abort.

Furthermore, a more detailed description of the cause can be read by right-clicking on the simulation under the Error message button.


Cause for termination of the simulation

400px
  • Simulation period is outside the date of the time series
  • In the state groups the calculation order was not updated when inserting new control groups
  • Overflow of storage elements, due to too large inflow or too small outflow. Inserting an emergency overflow is necessary.
  • Error in the rules and controls


Varianten kopieren / exportieren

Werden Varianten nicht kopiert oder exportiert, liegt es daran, dass keine aktive Simulation vorhanden ist. Der Grund könnte das Löschen der aktiven Simulation sein. Aus diesem Grund müssen Sie mit der rechten Maustaste auf die Simulation -> Simulation aktivieren in der zu kopierenden Variante klicken.


Fehlermeldungen im Systemeditor

"Die maximale Anzahl von <XXX> oder Systemelementen ist bereits vorhanden!"

Ursache: Die maximale Anzahl von Systemelementen eines bestimmten Typs ist bereits erreicht.

Lösung: Im Installationsverzeichnis die Datei \Client\TalsimNG\Definition\TalsimDef.mdb in Microsoft Access öffnen, darin die Tabelle "SystemobjektTyp" öffnen, und dort den Wert im Feld "MaximaleAnzahl" für den gewünschten Typ anpassen. Die Datenbank wieder schließen und Talsim neu starten, damit die Änderungen wirksam werden.